Kolmisuuntainen kippiperävaunu

FLIEGL Tandem-Seitenkipper TSK 210 T - 5 Meter

Custom-made transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored to individual customer requirements.

Chassis, central axle, tipping trailer
Steel welded construction, continuous tipping shaft at the rear with 100 mm ball bearing
Type 210, then total weight technically 21,000 kg (special permit required)
Gearbox support leg at the front
Retractable rear support
2 chocks with holder
Under-ride guard, steel
Splash guards at the rear over the entire width (not in conjunction with forklift holder)
Isdpfxszd Eyns Amrsic
Quarter panel fenders in front of and behind each axle
1 plastic toolbox, w=600 / h=425 / d=460 mm, lockable
1 pair of aluminum ramps, 3,440 mm long, 360 mm wide, load capacity per pair 8,000 kg (attachment rail for ramps at the rear)
Coupling device for central axle trailer
Drawbar with tested 50 mm tow hitch
Axles + suspension
BPW disc brake axles
"Axle/chassis laser-aligned" reduces tire wear and fuel consumption
Axle spacing 1810 mm (then 10 tons axle load technically)
Air suspension
Braking system
2-line compressed air brake system
Color-coded line routing for easy maintenance.
Spring brake parking brake
2 fail-safe coupling heads at the front, with connecting lines to the tractor unit,
24 Volt EBS, electronic braking system with EBS connector at the front, with connection cable,
Note: The trailer may only be towed by tractor units that guarantee the effectiveness of the ABS!
with lift and lower valve
Vehicle - driving stability system
Axle load detection via EBS-CAN bus signal, for display on the display in the driver's cab, truck must be correspondingly pre-equipped, no truck installation (no calibrated scale)
Wheels and tires
435/50 R19.5", manufacturer's choice
Tires with 164 K or J marking, manufacturer's choice
Steel rims, factory silver
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front in LED
2 white/red marker lights at the rear
2 x 7-pole fail-safe plugs at the front, with connection cable,
1 additional LED work light at the rear, switched via reversing light
Hydraulics
Three-way tipping mechanism, hydraulic multi-piston press with stroke limiter and safety cable,
Low-pressure cylinder up to max. 170 bar, without throttle. If required, this can be retrofitted to the truck. (Truck with max. hydraulic delivery rate of 55 l/min)
Operation hydraulically via truck PTO
Hydraulic connection with SVK plug NW 10/3, incl. connection hose
Tipping bridges
Steel sheet floor Hardox 450, 4 mm thick, ball bearing at the rear, 100 mm diameter
Side panel construction steel, side walls foldable and pivotally mounted with central locking at the bottom.
Rear wall pivotable and as a 2-wing door (not foldable), with door holder and protective rubber on the side (not in conjunction with pivot or mesh grating attachment)
Side wall retraction springs (not possible with foldable front wall)
Platform width 2420 mm
5 pairs of lashing eyes in the floor, 5 tons each
Painting
Side panels/bridge painted in desired color

Custom-made transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored to individual customer requirements.

Ilmoitus on käännetty automaattisesti. Käännösvirheitä saattaa esiintyä.