Kippiauto 3-tie

Fliegl TSK 140

Further information
Chassis central axle tipping trailer
Welded steel construction, continuous tipping shaft at the rear with 80 mm ball tipping bearing
2-speed gearbox support foot at the front
Folding rear support
Wheel chocks with holder
Steel underride guard
Rear spray flaps across the entire width
Quarter-shell mudguards
Lockable storage space for access ramps underneath the loading area
Towing device central axle trailer
Drawbar with tested 40 mm towing eye
Height-adjustable drawbar via spindle, max. adjustment range 300 mm
Axles + suspension
SAF drum brake axles
Axle/chassis laser-measured Reduction in tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearings and mechanical axle load compensation (rocker compensation)
Wheels and tires
285 / 70 R 19,5
manufacturer's choice
Factory silver steel rims
Brake system
2-line compressed air brake system
Spring-applied parking brake
2 non-interchangeable clutch heads at the front, with connecting lines to the motor vehicle, ABS and ALB, with ABS plug at the front, with connecting cable
Electrical system
24 volt, multi-chamber lights, amber LED lighting at the side
2 white position lights at the front
2 white/red lane departure lights at the rear
Lights completely in LED version (note! with certain towing vehicles, misdiagnosis can occur, although the function is given)
1 x 15-pin plug at the front, with connecting cable,
Hydraulics
Three-way tipping mechanism, hydraulic multi-piston press with lift limiter and safety cable,
Low-pressure cylinder up to max. 170 bar, without throttle. If necessary, this must be retrofitted to the truck.
Hydraulic operation via truck power take-off
Hydraulic connection with SVK plug NW 10/3, incl. connection hose
Tilting bridges
Fpedpfxji Ri Ipo Aarsd
Sturdy tipper body with 4 mm sheet steel floor, steel side wall structure, continuous side walls, hinged and pivoting with central locking at the bottom. Rear corner stanchions pluggable. Rear wall can be folded down and pivoted, with central locking at the bottom.
Platform length approx. 5,000 mm, side walls with 6 hinges at the bottom.
Dropside retraction springs (not possible with split side walls)
Rear wall hinged and as 2-leaf door (cannot be folded down), with door holder and protective rubber on the side
Platform width 2420 mm
5 pairs of lashing eyes in the floor, 5 tons each
Country of registration / plates
Country of registration: Germany
with Dekra approval and certificate (according to §13 EG - FGV)
24/7 service hotline
Prepared for single-line license plate holder
Contour marking with reflective strips in accordance with ECE R 048, white at the sides and red at the rear
Paintwork
Hot-dip galvanized frame incl. passivation15-year warranty against rusting through
Dropside/bridge RAL 3002, carmine red
Please note! Bridge only primed inside!
Attention: Archive pictures!

Ilmoitus on käännetty automaattisesti. Käännösvirheitä saattaa esiintyä.